But … as stated elsewhere, these cheap skeleton welds suck, but they are made of hardened steel, so I tried to drill a hole in the sex doll spinal joint for fixation, but on HD I The best drills you can’t buy have found nothing. I tried a hacksaw and a small one with a cutting wheel, but found nothing. Later, I will try to use the new one better, but I worry about the heat generated inside the tube and the TPE damage.
Greater TPE reductions may be required. At the same time, I found that I loved her great flexibility and personal responsiveness, as well as the interesting new poses she can do now. So … I am thinking of terry cloth tucks into the jagged gap to protect TPE and myself and keep it as it is. Then we will reduce some weight and use the right raw materials when closing the wound.
We don’t make tpe sex dolls almost as hot as the mold is poured, so the foam should be good, but I hope there is plastic around the foam so that it will not suck oil from tpe and dry, and the saturated foam will not save A lot of weight. The weld was torn, leaving a weld-sized hole on the top of the inverted U-shaped tube, which was speculated to be 1×2 cm, which caused the tube to become weak and unable to withstand the torque generated by further leg movement. There is a 140 cm thick TPE doll with hip joints that are too tight, and can only swing their legs when flat, and it takes a lot of time to move them.